• Prof. Praful Ulhe
• Rishabh Tiwari
• Ashish Sahu
• Rahul wagh

Turning is the most common method used in the industry during the manufacturing of the product. The main objective of the manufacturing plant is to produce good satisfying technology and technique, due to this MQL (Minimum quantity lubrication) machining has caught the attention of the researchers and technicians in the area of machining as an alternative to traditional fluid. This is necessary for the industry to develop such a technique to sustain in the competition. In MQL, we use only 5-40ml per hour of lubricant for turning operation. By using MQL technique we get better surface finishing and as we use less lubricant for machining operation, it results in the cost reduction of the product. We are doing our experiment on EN-31 in which we consider the following parameter such as cutting speed, depth of cut, feed rate and temperature also.

MQL (Minimum quantity lubrication), lubricant, EN-31, depth of cut, feed rate, temperature.

"Methodology of MQL System for Straight Turning Operation on CNC Lathe Machine", International Journal of Emerging Technologies and Innovative Research (www.jetir.org), ISSN:2349-5162, Vol.5, Issue 5, page no.508-510, May-2018, Available :http://www.jetir.org/papers/JETIR18IC095.pdf

"Methodology of MQL System for Straight Turning Operation on CNC Lathe Machine", International Journal of Emerging Technologies and Innovative Research (www.jetir.org | UGC and issn Approved), ISSN:2349-5162, Vol.5, Issue 5, page no. pp508-510, May-2018, Available at : http://www.jetir.org/papers/JETIR18IC095.pdf