• Soumyajit Das
• Asit Baran Chattopadhyay

Built-up Edge is a well-known phenomenon in the manufacturing industry which probably a danger for the quality of the semi-finished or finished product. This unfavorable incident hampered surface finish and reduce the life f tool. During any machining operation such as turning; the tool and the performed blank stick together like welding action. Under high compressive stress, seizure keeps the material from sliding over the cutting tool rake face. The presence or non-appearance of a developed edge (BUE) is significant according to apparatus wear and surface completion. The potential systems and cycles of wear impacted by the various kinds of the built-up edge were talked about in our study. Metallographic examinations have indicated that recrystallization happens in the streamed layer. The progression of sub microscopic crystallites over the tool-face affects tool wear. From the experiment, the most positive cutting conditions, from the perspective of both wear and surface completion, happen without a developed edge. This work and moderate reports on the investigation of the BUE calculation of C30 steel machined at low rates with and without a cutting liquid.

Built-Up Edge (BUE), Compressive stress, Tool Wear, C30 Steel, Re-crystallization, Surface finish

"Experimental study on role of tool-work materials and machining conditions on Built-up Edge Formation", International Journal of Emerging Technologies and Innovative Research (www.jetir.org), ISSN:2349-5162, Vol.8, Issue 3, page no.387-396, March-2021, Available :http://www.jetir.org/papers/JETIR2103057.pdf

"Experimental study on role of tool-work materials and machining conditions on Built-up Edge Formation", International Journal of Emerging Technologies and Innovative Research (www.jetir.org | UGC and issn Approved), ISSN:2349-5162, Vol.8, Issue 3, page no. pp387-396, March-2021, Available at : http://www.jetir.org/papers/JETIR2103057.pdf