• Dr. M.SIVARAJ
• Dr. RAMESH RUDRAPATI
• Dr. S.RAJKUMAR
• Mr. ARUN PATIL

In this study Titanium, Aluminum, Vanadium and boron carbide powders were milled separately in plantery ball mill for various milling time period. The properties of reinforcement particle size and weight percentage on plastic deformation behavior of composite powders were investigated. For every 1h the samples morphology was tested by using Scanning electron microscopefinally the individual powders were mixed with weight basis to produce novel Ti-6Al-4V-B4C composites. These composites were examined by again Scanning electron microscope to found the uniform distribution of the particles. The FT-IR spectra was used to confirm the presence of boron carbide particles in the base material. From the observation milling time period, reinforcement size and reinforcement content were strongly affecting the particle size and micro hardness of the composite powders.

Ti-6Al-4V, Boron carbide, SEM, FT-IR, Hardness

"CHARACTERIZATION OF B4C REINFORCEMENT ON TI-6AL-4VSINTERED COMPOSITE PREPARED BY SOLID-STATE AND POWDER PROCESSING TECHNIQUE METHOD", International Journal of Emerging Technologies and Innovative Research (www.jetir.org), ISSN:2349-5162, Vol.5, Issue 6, page no.150-155, June-2018, Available :http://www.jetir.org/papers/JETIRC006027.pdf

"CHARACTERIZATION OF B4C REINFORCEMENT ON TI-6AL-4VSINTERED COMPOSITE PREPARED BY SOLID-STATE AND POWDER PROCESSING TECHNIQUE METHOD", International Journal of Emerging Technologies and Innovative Research (www.jetir.org | UGC and issn Approved), ISSN:2349-5162, Vol.5, Issue 6, page no. pp150-155, June-2018, Available at : http://www.jetir.org/papers/JETIRC006027.pdf