• Ravikumar.S

The importance of materials in modern world can be realized from the fact that much of the research is being done to apply new materials to different components. This paper presents development the design and fabrication of bike Centre stand by using composite material. In this paper, the aim is to manufacture the composite Centre stand and compare the results with conventional steel stand under different mechanical testing with evaluating of different mechanical properties such as tensile strength, bending strength, impact strength, fatigue strength by using appropriate experimental technique.The present work is carried out on modelling, analysis and testing of Centre stand is to replace by different composite material for two wheeler vehicle. The stress and deflections of the Centre stand is going to be reduced by using the new composite material. The Centre stand was modelled in Pro/Engineer and the analysis was done using ANSYS workbench software. The fatigue life of both steel and composite material is compared using ANSYS software.

: Bike centrestand,Composite material, Pro/Engineer, ANSYS and Mechanical properties

"Design And Fabrication Of Bike Centre Stand Using Composite Materials ", International Journal of Emerging Technologies and Innovative Research (www.jetir.org), ISSN:2349-5162, Vol.5, Issue 6, page no.826-831, June-2018, Available :http://www.jetir.org/papers/JETIRC006147.pdf

"Design And Fabrication Of Bike Centre Stand Using Composite Materials ", International Journal of Emerging Technologies and Innovative Research (www.jetir.org | UGC and issn Approved), ISSN:2349-5162, Vol.5, Issue 6, page no. pp826-831, June-2018, Available at : http://www.jetir.org/papers/JETIRC006147.pdf