• J.Chandrasheker

In this paper the cutting of inconel 718 material using lathe by taguchi methodology. Taguchi optimization methodology is applied to optimize cutting parameters in turning inconel 718 material with carbide tipped tool under dry conditions. The lathe machine is used to conduct experiments based on the taguchi design of experiments (DOE) with orthogonal (L9) array. The orthogonal array signal to noise ratio (S/N) and analysis of variance were employed to find the minimum surface roughness. Optimum results are finally verified with the help of conformation experiments.

Turning process, speed, feed, depth of cut, inconel 718 material, taguchi method , Anova.

"OPTIMIZATION OF PARAMETERS IN TURNING FOR INCONEL 718 USING TAGUCHI METHOD", International Journal of Emerging Technologies and Innovative Research (www.jetir.org), ISSN:2349-5162, Vol.5, Issue 9, page no.583-587, September-2018, Available :http://www.jetir.org/papers/JETIRE006086.pdf

"OPTIMIZATION OF PARAMETERS IN TURNING FOR INCONEL 718 USING TAGUCHI METHOD", International Journal of Emerging Technologies and Innovative Research (www.jetir.org | UGC and issn Approved), ISSN:2349-5162, Vol.5, Issue 9, page no. pp583-587, September-2018, Available at : http://www.jetir.org/papers/JETIRE006086.pdf