• K. Sudharshan
• Dr. R Jhonson Uthaya Kumar

Solar photovoltaic (SPV) array based water pumping is receiving wide attention now a days because the everlasting solar energy is the best alternative to the conventional energy sources. This paper deals with the utilization of a buck - boost converter in solar PV array based water pumping as an intermediate DC-DC converter between a solar PV array and a voltage source inverter (VSI) in order to achieve the maximum efficiency of the solar PV array and the soft starting of the permanent magnet brushless DC (BLDC) motor by proper control. Consisting of a least number of components and single switch, the buck-boost converter exhibits very good conversion efficiency. Moreover, buck–boost DC–DC converter topology is the only one allowing follow-up of the PV array maximum power point (MPP) regardless of temperature, irradiance, and connected load. A BLDC motor is employed to drive a centrifugal type of water pump because its load characteristic is well matched to the maximum power locus of the PV generator. The transient, dynamic and steady state behaviors of the proposed solar PV array powered buck-boost converter fed BLDC motor driven water pumping system are evaluated under the rapid and slowly varying atmospheric conditions using the sim-power- system toolboxes of the MATLAB/Simulink environment.

SPV array, Buck-boost converter, VSI, soft starting, BLDC motor, Centrifugal pump.

"Solar PV Array Based BLDC Motor With Buck-Boost Converter FED Drive", International Journal of Emerging Technologies and Innovative Research (www.jetir.org), ISSN:2349-5162, Vol.5, Issue 10, page no.66-74, October-2018, Available :http://www.jetir.org/papers/JETIRJ006011.pdf

"Solar PV Array Based BLDC Motor With Buck-Boost Converter FED Drive", International Journal of Emerging Technologies and Innovative Research (www.jetir.org | UGC and issn Approved), ISSN:2349-5162, Vol.5, Issue 10, page no. pp66-74, October-2018, Available at : http://www.jetir.org/papers/JETIRJ006011.pdf