• Prof. Dinesh A. Yelure
• Gaurav D. Mute
• Rushabh A. Gawande
• Anil N. Gadekar

A Lifting Device is used to lift heavy objects. In the lifting device we are used 4 stage hydraulic telescopic jack. The advantages of telescopic jack are that the height of jack can be adjusting one inside the other (i.e. collapsed height). Present paper includes the analysis of The Device Made Using Hydraulic Telescopic Jack. The maximum load to be lift is 1000 kg up to the height of 40 inch (1016mm). With the help of CATIA the 3-D modelling of a device using 4 stages hydraulic telescopic jack is made. In ANSYS software we mainly do analyses of stress like circumferential stress, longitudinal stress, radial stress and equivalent stress. The components that are going to analyze are telescopic cylinder, plate rod and wheel at last the result are check for validation purpose. We show result comparing with theoretical value and analysis value. For lifting load carrying capability of device affected by different stress acting on it.

ANSYS analysis of telescopic jack, cylinder, plates, rods, 3D Modelling of Lifting Device.

"DESIGN ANALYSIS OF LIFTING DEVICE USING HYDRAULIC TELESCOPIC JACK", International Journal of Emerging Technologies and Innovative Research (www.jetir.org), ISSN:2349-5162, Vol.5, Issue 6, page no.494-500, June-2018, Available :http://www.jetir.org/papers/JETIR18IC093.pdf

"DESIGN ANALYSIS OF LIFTING DEVICE USING HYDRAULIC TELESCOPIC JACK", International Journal of Emerging Technologies and Innovative Research (www.jetir.org | UGC and issn Approved), ISSN:2349-5162, Vol.5, Issue 6, page no. pp494-500, June-2018, Available at : http://www.jetir.org/papers/JETIR18IC093.pdf