• Doradla Guru Charan Kumar
• M.D Ali

This project is about the application of reverse engineering, reverse engineering helps in obtaining the geometry of part or products which are not available otherwise. Its application makes it possible to reconstruct the original component with its drawing and manufacturing process. In this proposed work a sprocket will be produced by reverse engineering. The procedure includes various stages which involves the different phases of reverse engineering. The process starts with the understanding the reverse engineering procedure. The part geometry is going to obtain with the help of different measuring instruments. Then NX CAD software will be used for drawing and drafting, further the ANSYS software will be used for analysis of sprocket. Duplex stainless steel will be used for the manufacturing of sprocket. Because of its composition it will provide more strength and toughness to the sprocket. In this project report existing motorcycle sprocket is compared with the sprocket of duplex steel material. With different properties of mild steel, cast iron, duplex steel. Stress and deformation of sprocket is compared. This work can be useful for further development of sprockets.

REVERSE ENGINEERING, NX CAD, ANSYS, DUPLEX STEEL, DURABILITY.

"EXPERIMENTAL INVESTIGATION ON SPROCKET DEVELOPMENT USING NX CAD AND CAE BY REVERSE ENGINEERING", International Journal of Emerging Technologies and Innovative Research (www.jetir.org), ISSN:2349-5162, Vol.8, Issue 12, page no.b464-b477, December-2021, Available :http://www.jetir.org/papers/JETIR2112155.pdf

"EXPERIMENTAL INVESTIGATION ON SPROCKET DEVELOPMENT USING NX CAD AND CAE BY REVERSE ENGINEERING", International Journal of Emerging Technologies and Innovative Research (www.jetir.org | UGC and issn Approved), ISSN:2349-5162, Vol.8, Issue 12, page no. ppb464-b477, December-2021, Available at : http://www.jetir.org/papers/JETIR2112155.pdf