• Rohit Hardiya
• Jaypalsinh Rana
• Darshan K Bhatt

In this paper we use the Taguchi technique for the optimization of parameters on aluminium 6063 workpiece. The three significant parameters which are depth of cut, feed rate and spindle speed are used as a input parameters for experiment. These three parameters are at three levels. The number of experiments has been selected using Orthogonal array in the design of experiments. And to identify the effects of parameters on workpiece the analysis of variance is used. By using minitab software the mean plot effect and anova table is generated.

Thread Turning, Threading, Lathe, Taguchi method, Annova, Cutting forces, aluminium 6063, dynamometer.

"Analysis Of Cutting Forces Of Lathe Threading Operation Using Dynamometer On Aluminium 6063", International Journal of Emerging Technologies and Innovative Research (www.jetir.org), ISSN:2349-5162, Vol.10, Issue 2, page no.b741-b747, February-2023, Available :http://www.jetir.org/papers/JETIR2302197.pdf

"Analysis Of Cutting Forces Of Lathe Threading Operation Using Dynamometer On Aluminium 6063", International Journal of Emerging Technologies and Innovative Research (www.jetir.org | UGC and issn Approved), ISSN:2349-5162, Vol.10, Issue 2, page no. ppb741-b747, February-2023, Available at : http://www.jetir.org/papers/JETIR2302197.pdf