• Swastik Pradhan
• -

Abstract: 3D simulation of turning process is carried out through Deform-3D software. The workpiece considered for the simulation is Grade 5 of titanium alloy. The dry turning simulation operation is performed with uncoated cutting insert. Optimization of the simulation increases the productivity. Hence, Modeling and simulation closed to the actual cutting process have to be taken in account in terms of the thermal analysis. The 3D simulation is simulated as per the Taguchi L9 orthogonal array. Three cutting parameters is varied at three different level. The cutting temperature data as per the experimental layout are recorded and the effect of cutting parameter on cutting temperature are discussed. Result revealed that increasing in cutting speed the cutting temperature increases.

Keyword: Deform-3D, Cutting temperature, titanium alloy, Process simulation,

"Cutting temperature prediction during machining of titanium alloy using DEFORM-3D", International Journal of Emerging Technologies and Innovative Research (www.jetir.org), ISSN:2349-5162, Vol.5, Issue 11, page no.621-629, November 2018, Available :http://www.jetir.org/papers/JETIRDS06091.pdf

"Cutting temperature prediction during machining of titanium alloy using DEFORM-3D", International Journal of Emerging Technologies and Innovative Research (www.jetir.org | UGC and issn Approved), ISSN:2349-5162, Vol.5, Issue 11, page no. pp621-629, November 2018, Available at : http://www.jetir.org/papers/JETIRDS06091.pdf