• Vivek Sharma

This paper aims to determine the stress of MR fluids in an on-state condition. Different MR fluids samples were made and tested inside the laboratory. The equipment was made to test the fluid. In the experimentation, it was found that MR fluids have high stress and can be used in military design and fabrication. This paper paves away for any researcher to develop MR fluids at very less cost. The MR fluids have very high yield stress which depends on the particles being used in their formulation. It can be concluded that MR fluids yield stress can be found in an economical manner using a set up and can be used in various engineering ventures.It is also evident that yield stress of MR fluid depends upon the magnetic flux density produced by fluid particles. The amount of fluid particles is responsible for increase in shear stress produced by MR fluid. However the amount of fluid particles should not increase 60% otherwise the sedimentation problem is encountered.

"Study of rheological characteristics of MR fluids ", International Journal of Emerging Technologies and Innovative Research (www.jetir.org), ISSN:2349-5162, Vol.6, Issue 1, page no.2156-2159, January 2019, Available :http://www.jetir.org/papers/JETIRDY06342.pdf

"Study of rheological characteristics of MR fluids ", International Journal of Emerging Technologies and Innovative Research (www.jetir.org | UGC and issn Approved), ISSN:2349-5162, Vol.6, Issue 1, page no. pp2156-2159, January 2019, Available at : http://www.jetir.org/papers/JETIRDY06342.pdf