• 1Adarsha H
• Ashutosh Pattanaik

The Metal has been undergo heat at temperatures far below melting point, deposition of particles occurs in the cold spray phase by intense plastic deformation on contact in a solid state. In this phase spray particles therefore undergo no oxidation or decomposition. As something of a result, coatings which are scattered cold have outstanding mechanical, electrical in addition to thermal properties. In this job cold spray deposited pure Al, Ti ,Cu, and steel 326. Those coatings also assessed the tensile strength including elongation. The findings showed that there is low ductility and almost no elongation in the as-sprayed coatings of the four products. Heat treatment can however to some degree improve mechanical properties in case of cold-sprayed covering over the surface of metal. Here, it addresses consequences of treatment situations on both mechanical qualities of cold-sprayed products.

Brittle, Cold spray, Fracture, surface Heat treatment, Tensile strength.

"Heat Treatment on Mechanical Characteristics of Cold-Sprayed Coatings", International Journal of Emerging Technologies and Innovative Research (www.jetir.org), ISSN:2349-5162, Vol.6, Issue 2, page no.513-518, February-2019, Available :http://www.jetir.org/papers/JETIREV06082.pdf

"Heat Treatment on Mechanical Characteristics of Cold-Sprayed Coatings", International Journal of Emerging Technologies and Innovative Research (www.jetir.org | UGC and issn Approved), ISSN:2349-5162, Vol.6, Issue 2, page no. pp513-518, February-2019, Available at : http://www.jetir.org/papers/JETIREV06082.pdf