Contact Us
Click Here

"STATISTICAL PARAMETRIC STUDY OF ABRASIVE JET MACHINING ", International Journal of Emerging Technologies and Innovative Research (www.jetir.org), ISSN:2349-5162, Vol.5, Issue 1, page no.20-24, January-2018, Available :http://www.jetir.org/papers/JETIR1801005.pdf

• ramesh panda
• Gurpreet Singh
• Kamlesh Kumar Singh
• Rajesh Kumar

This paper deals with statistical modeling study of abrasive jet machining process influence of process parameters (material removal rate). Diameter of holes of glass plates using different types of abrasive used for the experimental values. The results of the present work are used to discuss the validity of proposed model. With the increase in nozzle tip distance (NTD), the top surface diameter and bottom surface diameter of hole increases as it is in general observation of abrasive jet machining process. Present study has been introduced a statistical model and the obtained results analysis obtained through dual parametric Z-Test and ANOVA for experimental studies. This paper will help students, manufactures and researchers, to understand policy makers and optimized working parameters widely.

"STATISTICAL PARAMETRIC STUDY OF ABRASIVE JET MACHINING ", International Journal of Emerging Technologies and Innovative Research (www.jetir.org | UGC and issn Approved), ISSN:2349-5162, Vol.5, Issue 1, page no. pp20-24, January-2018, Available at : http://www.jetir.org/papers/JETIR1801005.pdf