• Priya Gajjal
• Shekhar Gajjal

The aim of this research was to investigate and analyze the wear of sintered dry bearing material. A mathematical model considering lump parameters was developed using dimensional analysis technique and expressed in terms of the operating parameters and constructional parameter of the material. Tribo-experiments were conducted on a dedicated test set-up which simulates the actual contact conditions as practiced in industry. This paper highlighted the wear characteristics of a sintered dry bearing material under sliding contact conditions to anticipate possible wear regime.

Wear model, Dimensional analysis, Sintered material, Dimensional analysis, wear

"Wear Model of Dry Sintered Bearing Material by Dimensional Analysis", International Journal of Emerging Technologies and Innovative Research (www.jetir.org), ISSN:2349-5162, Vol.6, Issue 5, page no.528-534, May-2019, Available :http://www.jetir.org/papers/JETIR1905F80.pdf

"Wear Model of Dry Sintered Bearing Material by Dimensional Analysis", International Journal of Emerging Technologies and Innovative Research (www.jetir.org | UGC and issn Approved), ISSN:2349-5162, Vol.6, Issue 5, page no. pp528-534, May-2019, Available at : http://www.jetir.org/papers/JETIR1905F80.pdf