• Narayandas pratap
• V.Shivashankar
• R.Ravi Kumar
• Sachin Kamble
• B.Rahul

The main aim of our project is fabrication of mechanical pest sprayer we have design a model running without any fuel and also easy to operate for a user. In this model we find that we have simply used a sprocket mounted on rear shaft which will actuate piston inside cylinder in the tank. Also the assembly consists of 4wheels out of which two are mounted on front shaft and two are mounted as guide wheel at rear end. A sprocket is mounted on front side exactly at the end of shaft. By pushing the trolley, sprocket rotates in its direction so it actuates the piston inside the cylinder, due to this the compression takes place inside the tank. So it leads to spray pesticides (or) water inside the tank. In our project, spraying is done by using sprocket mechanism. This pest sprayer requires less man work for spraying as comparing to regular methods.

FABRICATION OF MECHANICAL PEST SPRAYER

"FABRICATION OF MECHANICAL PEST SPRAYER", International Journal of Emerging Technologies and Innovative Research (www.jetir.org), ISSN:2349-5162, Vol.6, Issue 5, page no.256-260, May-2019, Available :http://www.jetir.org/papers/JETIR1905G37.pdf

"FABRICATION OF MECHANICAL PEST SPRAYER", International Journal of Emerging Technologies and Innovative Research (www.jetir.org | UGC and issn Approved), ISSN:2349-5162, Vol.6, Issue 5, page no. pp256-260, May-2019, Available at : http://www.jetir.org/papers/JETIR1905G37.pdf