• Tejas N
• Sharanabasavesh Shedadale
• Srinatha
• Namratha N
• Anand S N

Automation is the prime key for the next generation of Industrial work, i.e., Industry 4.0, and based on this, research work has been done on automatic staging of metal injection molded parts in the work cell. Existing work procedure consists of man power for staging of components but the industry requirement is a fully automated working cell. The prime motto is to make work effective and faster without any errors. An important factor to be considered is precise staging of the components where it should not get affected during the next two processes. By taking all these factors into consideration,a new design for automatic staging of components has been done. The design comprises of Robotic arms, shuttle system, conveyor belts, EOAT’s etc. Hence without affecting the present working cycle time of the machine, an automatic staging of the components is designed and implemented for the working cell

MIM, Fixtures, Shuttle,Delrin, EOAT (End of arm tool), Cycle Time

"IMPLEMENTATION OF STAGING AUTOMATION SYSTEM FOR METAL INJECTION MOLDED PARTS", International Journal of Emerging Technologies and Innovative Research (www.jetir.org), ISSN:2349-5162, Vol.6, Issue 5, page no.143-149, May-2019, Available :http://www.jetir.org/papers/JETIRBZ06023.pdf

"IMPLEMENTATION OF STAGING AUTOMATION SYSTEM FOR METAL INJECTION MOLDED PARTS", International Journal of Emerging Technologies and Innovative Research (www.jetir.org | UGC and issn Approved), ISSN:2349-5162, Vol.6, Issue 5, page no. pp143-149, May-2019, Available at : http://www.jetir.org/papers/JETIRBZ06023.pdf