• AAKASH TRISTAN STALIN.P
• ARVINTH SINGHSON.J
• MOHAMED FIZAL.M
• VIGNESH.R
• VAITHEESWARAN.V.M

Recycling waste plastics into reusable plastic products is a conventional strategyfollowed to address this issue for years. However, this technique has not given impressive results as cleaning and segregation of waste plastics was found difficult. Over 100 million tonnes of plastics are produced annually worldwide, and the used products have become a common feature at overflowing bins. Plastics is placed in a landfill, it becomes a carbon sink, Incineration, blast furnace, gasification are not much-appreciated a solution to the problem, as toxic gases are produced and their cost of production is quite high. Pyrolysis of waste plastics into fuel is one of the best means of conserving valuable petroleum resources in addition to protecting the environment. This process involves catalytic degradation of waste plastic into fuel range hydrocarbon i.e. petrol, diesel, and kerosene, etc. A catalytic cracking process in which waste plastic was cracked at very high temperature, the resulting gases were condensed to recover liquid fuels. Type of plastics also affect the rate of conversion of into fuel and the results of this process are found to be better than other alternative methods which are used for the disposal of waste plastic.

Waste Plastic, Pyrolysis Method, Condensation, Fuel

"PRODUCTION OF FUEL FROM PLASTIC WASTE", International Journal of Emerging Technologies and Innovative Research (www.jetir.org), ISSN:2349-5162, Vol.6, Issue 5, page no.142-145, May-2019, Available :http://www.jetir.org/papers/JETIRCI06031.pdf

"PRODUCTION OF FUEL FROM PLASTIC WASTE", International Journal of Emerging Technologies and Innovative Research (www.jetir.org | UGC and issn Approved), ISSN:2349-5162, Vol.6, Issue 5, page no. pp142-145, May-2019, Available at : http://www.jetir.org/papers/JETIRCI06031.pdf