• Usha G
• Sunanda v
• Roopa N
• Afroj Y
• Trivedi R

Recent incident in aircraft navigation in air and on ground, resulted in loss of lives of high profile citizens .so there is a need for anti collision system .Air traffic collision avoidance systems are based on using data supplied by external sources and internal sources, but the pilot has ultimate responsibility for air collision prevention. This project aims on the use of zigbee module which is connected to the Arduino uno board and the signal from the zigbee sends to the receiver if any aircraft is detected by the transmitter. Then the “aircraft is detected” message will displayed on the LCD screen ,buzzer will activated, by this pilot can take certain measurements when aircraft moves away from aircraft“ normal mode” message will displayed on the LCD screen, buzzer sound turned off. All these conditions are reported to the ground station over IOT .

Arduino UNO , IOT, LCD screen, Zigbee

"AIR CRAFT ANTI COLLISION SYSTEM USING ARDUINO ", International Journal of Emerging Technologies and Innovative Research (www.jetir.org), ISSN:2349-5162, Vol.6, Issue 5, page no.220-222, May-2019, Available :http://www.jetir.org/papers/JETIRCJ06049.pdf

"AIR CRAFT ANTI COLLISION SYSTEM USING ARDUINO ", International Journal of Emerging Technologies and Innovative Research (www.jetir.org | UGC and issn Approved), ISSN:2349-5162, Vol.6, Issue 5, page no. pp220-222, May-2019, Available at : http://www.jetir.org/papers/JETIRCJ06049.pdf