• Swastik Pradhan

The three-dimensional simulation of turning process is carried out by Deform-3D software. The Grade 2 of titanium alloy is considered as the workpiece. The dry turning operation is done by using uncoated cutting insert. Enhancement of the recreation expands the profitability. Subsequently, Modeling and prediction shut to the genuine turning process must be considered as far as the stress examination. The 3D machining simulation is reenacted according to the Taguchi L9 symmetrical array. Three cutting parameters is changed at three diverse level. The effective stress information according to the trial design are recorded and the impact of cutting parameter on Effective stress are talked about. Result uncovered that speeding up the cutting speed increased the effective stress.

Effective stress, Deform-3D, Grade 2 alloy, Turning simulation

"Effective-stress expectation during turning operation of grade 2 utilizing DEFORM-3D", International Journal of Emerging Technologies and Innovative Research (www.jetir.org), ISSN:2349-5162, Vol.6, Issue 1, page no.1713-1721, January 2019, Available :http://www.jetir.org/papers/JETIRDY06273.pdf

"Effective-stress expectation during turning operation of grade 2 utilizing DEFORM-3D", International Journal of Emerging Technologies and Innovative Research (www.jetir.org | UGC and issn Approved), ISSN:2349-5162, Vol.6, Issue 1, page no. pp1713-1721, January 2019, Available at : http://www.jetir.org/papers/JETIRDY06273.pdf