• Amol Pitambar Mali
• Pratik Vijay More
• Pranav R. Navasare
• Vaibhav Kiran Nemade
• Sagar. B. Deokar

Motorcycles are widely used around the world particularly in INDIA. The gear shifting system of the motor-cycle is conventionally manual. This report covers development of an indigenous gear shifting changing system for the standard motorcycle. By this system the manual mechanical gear shifting will remain unchanged because an additional switch control system will be provided on the handles. So, the system has both the option manual as well as automatic. The system uses low-cost microcontrollers to make the accurate decision for shifting the gear up and down by observing the speed, and it controls the clutch transmission where necessary. The ELECTRO MECHANICAL GEAR SHIFTER mode will require input from the user to shift between gears using switches or buttons. The switches will be operated to instruct the motor to shift the gear. This will enable the user to shift gears using hands and can also always use the manual transmission if desired. The AUTOMATIC GEAR SHIFTER mode will consist of a microcontroller to make decision of changing the gears based on the reply of the wheel. It will use sensors and same actuation mechanism used for electromechanical system.

Electrical gear shifting, Catia, Creo, Ansys Workbench, Thermal analysis, static analysis, etc.

"DESIGN AND MANUFACTURING OF ELECTRICAL GEAR SHIFTER FOR GO – KART", International Journal of Emerging Technologies and Innovative Research (www.jetir.org), ISSN:2349-5162, Vol.10, Issue 5, page no.658-661, May-2023, Available :http://www.jetir.org/papers/JETIRFX06115.pdf

"DESIGN AND MANUFACTURING OF ELECTRICAL GEAR SHIFTER FOR GO – KART", International Journal of Emerging Technologies and Innovative Research (www.jetir.org | UGC and issn Approved), ISSN:2349-5162, Vol.10, Issue 5, page no. pp658-661, May-2023, Available at : http://www.jetir.org/papers/JETIRFX06115.pdf