• Prof. K.G.Sontakke
• Prof. R. D. Vaidya
• Prof. D.M. Mate

The objective is to design and analyse the drilling cum riveting machine which reduces the operation as well as transportation time required for completing the job. Riveting operation is till now performed manually, but by using Orbital Riveting Machine (ORM) it can be performs automatically. The concept is that the plate (raw material) having different size and thickness are drilled on drilling spindle first and then riveted on orbital riveting spindle. Both the operations perform on same machine having two separate spindles. The purpose of this machine is to replace manual hammering into automation, to increase productivity in operation also to reduce cost. To get accuracy in riveting the spindle is offset by 3 to 6 degree, the upper part of rivet stud is expanding over plates without hammering. It is more beneficial to use in workshops, industries where drilling and riveting operations can perform simultaneously.

Automation, Drilling cum orbital riveting, increase productivity, separate spindles, 3 to 6 degrees offset spindle, etc,

"Design and Analysis of Drilling Cum Riveting Machine", International Journal of Emerging Technologies and Innovative Research (www.jetir.org), ISSN:2349-5162, Vol.1, Issue 6, page no.419-426, November-2014, Available :http://www.jetir.org/papers/JETIR1406009.pdf

"Design and Analysis of Drilling Cum Riveting Machine", International Journal of Emerging Technologies and Innovative Research (www.jetir.org | UGC and issn Approved), ISSN:2349-5162, Vol.1, Issue 6, page no. pp419-426, November-2014, Available at : http://www.jetir.org/papers/JETIR1406009.pdf