• Mihir Thakorbhai Patel

This paper deals with the optimization of machining parameters in rough turning of E 250 B0 of standard IS: 2062 using carbide insert. During the experiments, controllable parameters like speed, feed and depth of cut are used to explore the effect on material removal rate. The optimization of material removal rate is done using nine experimental runs base on L9 orthogonal array by using Taguchi method. After conducting the experiments the material removal rate was measured and Signal to Noise ratio was calculated. With the help of graphs of raw and SN ratio data, optimum parameter values were obtained and the confirmation experiments were carried out. These results were compared with the results of full factorial method.

ANOVA, Design of Experiments, Material Removal Rate, Orthogonal Array, SN Ratio, Taguchi Method

"Experimental Investigation of Material Removal Rate in CNC TC Using Taguchi Approach", International Journal of Emerging Technologies and Innovative Research (www.jetir.org), ISSN:2349-5162, Vol.2, Issue 2, page no.203-210, February-2015, Available :http://www.jetir.org/papers/JETIR1502008.pdf

"Experimental Investigation of Material Removal Rate in CNC TC Using Taguchi Approach", International Journal of Emerging Technologies and Innovative Research (www.jetir.org | UGC and issn Approved), ISSN:2349-5162, Vol.2, Issue 2, page no. pp203-210, February-2015, Available at : http://www.jetir.org/papers/JETIR1502008.pdf