• JAWAHAR LAL
• Dr. LINI MATHEW

D-STATCOM is a compensation device that is used to control the flow of reactive power in distribution systems. Most of the loads in this system, being of inductive nature, consume more reactive power. As a result, the power factor of the load deteriorates and this limits the flow of active power in the line. The document aims to develop a D-STATCOM, based on the voltage source converter, which injects the reactive power into the distribution line. The output voltage of D-STATCOM is brought to the system voltage to control the generation of VAR. The implementation of D-STATCOM through the use of the PI controller is carried out in MATLAB / Simulink

D-STATCOM, voltage source converter (VSC), reactive power.

"Simulation in the Distribution System and comparing by Using D-STATCOM and DVR are connected to Grid during voltage sag Problems", International Journal of Emerging Technologies and Innovative Research (www.jetir.org), ISSN:2349-5162, Vol.5, Issue 9, page no.1106-1110, September-2018, Available :http://www.jetir.org/papers/JETIR1809297.pdf

"Simulation in the Distribution System and comparing by Using D-STATCOM and DVR are connected to Grid during voltage sag Problems", International Journal of Emerging Technologies and Innovative Research (www.jetir.org | UGC and issn Approved), ISSN:2349-5162, Vol.5, Issue 9, page no. pp1106-1110, September-2018, Available at : http://www.jetir.org/papers/JETIR1809297.pdf