• Satyaprakash gaur
• P.S. Dhakar

The Engine chamber is one of the essential engine components, that is subjected to over the top temperature differences and thermal stresses. Fins are set on the surface of the cylinder to improve the quantity of heat exchange by convection. The present examination gives the heat exchange investigation between plate fins and pin fins. pins fins composed in two shapes (circular, rectangular) fitted with tube-shaped cross-sectional so as to decide better improvement in the heat exchange rate. we have optimized Heat exchange rate and optimized with all perspectives to get higher Heat exchange rate. In the present work, Experiments have been performed to discover the temperature variations inside the fins made in three kind geometries (plate Fins, Circular Pin fins, and Rectangular pin fins) and consistent state heat exchange examination has been studied utilizing a finite element software ANSYS to test and approve results. The temperature variations at various areas of pin fins are evaluated by FEM and compared plate fins result with the results of pin fins obtained by experimentally in Ansys. The principle implemented in this project is to expand the heat dissipation rate by utilizing the wind flow. The main aim of the study is to enhance the thermal properties by shifting geometry, material, and design of fins.

heat transfer, Extended surfaces, Thermal analysis, FEM, Analysis and Heat transfer enhancement.

"Heat transfer Analysis between Plate Fins and Pin Fins Using Ansys", International Journal of Emerging Technologies and Innovative Research (www.jetir.org), ISSN:2349-5162, Vol.5, Issue 9, page no.668-675, September-2018, Available :http://www.jetir.org/papers/JETIR1809607.pdf

"Heat transfer Analysis between Plate Fins and Pin Fins Using Ansys", International Journal of Emerging Technologies and Innovative Research (www.jetir.org | UGC and issn Approved), ISSN:2349-5162, Vol.5, Issue 9, page no. pp668-675, September-2018, Available at : http://www.jetir.org/papers/JETIR1809607.pdf