• ravinder
• Manoj pandey

The non-conventional machining specially EDM is one of the best technique for improvement of mechanical properties such as material removal rate (MRR), surface roughness, Tool wear rare, by different combination of electrodes. However, while machining, machining parameters also being very effective. In our study, we carried out an experiment to atomize the outcome of machining characteristics viz. discharge current (Ip), pulse on time (Ton), voltage (v) over the responses of MRR and SR. For carrying this Tungsten carbide tool was used and work piece chosen was AISI 304 stainless steel. AISI304 stainless steel is used for various purpose in many day to day life as well as engineering applications. An orthogonal array had been used for running the experiment. Among all the process parameters we analyze that pulse on time is most significant next to discharge current is over response of MRR and voltage is effective parameter for performing surface roughness. For the experimental analysis STATISTICA 9.0 software is used.

electrode,sourface roughness,material removal rate,tungsten carbide

"Parametric Optimization of Process Parameters For EDM of Stainless Steel 304", International Journal of Emerging Technologies and Innovative Research (www.jetir.org), ISSN:2349-5162, Vol.5, Issue 10, page no.288-303, October-2018, Available :http://www.jetir.org/papers/JETIR1810058.pdf

"Parametric Optimization of Process Parameters For EDM of Stainless Steel 304", International Journal of Emerging Technologies and Innovative Research (www.jetir.org | UGC and issn Approved), ISSN:2349-5162, Vol.5, Issue 10, page no. pp288-303, October-2018, Available at : http://www.jetir.org/papers/JETIR1810058.pdf