• ANKIT MODI
• Prof. SANJAY SARASWAT

Crumb rubber tire is quite easily available and is very low in cost, due to day by day increase in cost of stabilizers like cement, lime and other ad mixers use of crumb rubber tire can result in project completion optimally. The soil sample used is clay which requires to be strengthened due to presence of high plasticity; this soil sample is strengthened by using varying proportion of crumb rubber tire. Various tests were conducted to analyze the effect of crumb rubber tire on optimum moisture content, maximum dry density and California bearing ratio. Results shows decrease in optimum moisture content but decrease in maximum dry density, Along with increase in California bearing ratio, from the observations it can be seen that 2%, 4%, 6%, 8% and 10% results in maximum improvement in desired soil properties. The One of chances to dispose of this waste material is to use these refuses, as a stabilizer in soils, in order to increase the strength properties and the bearing capacity of the soil-stabilizer mix. Discarded tire are becoming globally problematic because recycling them may cause environment related problem. Thus, making use of them needs to be considered and solution must be sustainable. Crumb rubber should cover social, environmental, and economic sustainability. Now days the waste tire are increasingly being considered as construction material. The study was shown clay soil-crumb rubber of 10% stabilization can be used as fill material in sub grade of highway construction.

waste Crumb rubber tire, C.B.R, Optimum moisture content, maximum dry density, Stabilization.

"soil stabilization using waste crumb rubber tire", International Journal of Emerging Technologies and Innovative Research (www.jetir.org), ISSN:2349-5162, Vol.5, Issue 12, page no.446-450, December-2018, Available :http://www.jetir.org/papers/JETIR1812262.pdf

"soil stabilization using waste crumb rubber tire", International Journal of Emerging Technologies and Innovative Research (www.jetir.org | UGC and issn Approved), ISSN:2349-5162, Vol.5, Issue 12, page no. pp446-450, December-2018, Available at : http://www.jetir.org/papers/JETIR1812262.pdf