• Akshay Wakodikar
• Nirat Pardikar
• Nikhil Nannaware
• Prof. Santosh Kumar

This paper concentrates on explaining the design, manufacturing and engineering aspects of making a Go-Kart for karting championship. We had made a go-kart having creativity with a few restrictions mentioned in the rule book. This paper deals with objectives, assumptions, calculations, and fabrication of Go-Kart. Our primary objective is to design a safe, functional and cost-effective vehicle based on rigid and torsion free frame. The design is chosen such that the Kart is easy to fabricate in every possible manner. The first stage is did some literature review about the existing go-kart there components and go-kart chassis. Then we Design, Simulate and perform the static analysis of critical components like Chassis and Shaft of a racing go-kart. Modeling, simulations and analysis are performed using 3-D software such as Creo 3.0 and ANSYS. Chassis is of a tubular cross section pipe, fabricated assembly is of AISI 4130 grade and a few other grades. In this kart we have used AISI 4130 class tube with 1 inch diameter and 2 mm wall thickness.

Go-kart, material selection, chassis impact, braking system.

"A Review Paper on Fabrication of Go-Kart", International Journal of Emerging Technologies and Innovative Research (www.jetir.org), ISSN:2349-5162, Vol.6, Issue 1, page no.195-202, January-2019, Available :http://www.jetir.org/papers/JETIR1901928.pdf

"A Review Paper on Fabrication of Go-Kart", International Journal of Emerging Technologies and Innovative Research (www.jetir.org | UGC and issn Approved), ISSN:2349-5162, Vol.6, Issue 1, page no. pp195-202, January-2019, Available at : http://www.jetir.org/papers/JETIR1901928.pdf