• Tanmay P. Parekh
• Javal J. Patel
• Devang R. Jani

There are two approaches for engineering of this structures: Stick built approach and Modular approach. This paper focuses on the concepts of Modularization which is a Modular type of approach. The major challenge in modularization is understanding that how structure will behave during the different phases of modularization life cycle. That is its behaviour during transportation (Road/Sea), Lifting and operating condition (at site). As there are different stages involved in the modularization, one should have a brief knowledge about additional loads which acts on structure in different phases. The scope of this study is to correctly design a modular process structure of 14 m x 12 m x 10.5 m (tall) structure addressing it precisely in mathematical model. Here entire structure is divided in modules which can be truck mounted (3.45 m x 3.45 m x 12 m) including all the equipment and piping assemblies mounted inside it. P-delta analysis will be performed for deflection and direct analysis method will be carried out for the strength as per AISC 360-05. For the design of module AISC 360-05 shall be used and Similarly ASCE 07-05 will be used for loads and load combination. Here an attempt will be made to develop the procedure for designing the truck mounted modular structure.

Modularization, Truck mounted modules, Stick-built, Process structure

"ASPECTS OF MODULARIZATION – PARAMETRIC STUDY OF TRUCK MOUNTED MODULE IN OIL AND GAS INDUSTRY ", International Journal of Emerging Technologies and Innovative Research (www.jetir.org), ISSN:2349-5162, Vol.6, Issue 4, page no.37-42, April-2019, Available :http://www.jetir.org/papers/JETIR1904806.pdf

"ASPECTS OF MODULARIZATION – PARAMETRIC STUDY OF TRUCK MOUNTED MODULE IN OIL AND GAS INDUSTRY ", International Journal of Emerging Technologies and Innovative Research (www.jetir.org | UGC and issn Approved), ISSN:2349-5162, Vol.6, Issue 4, page no. pp37-42, April-2019, Available at : http://www.jetir.org/papers/JETIR1904806.pdf