• Mr. Raj C Patel
• Mr. Hitesh R.Raiyani

A pressure vessel is designed for performing hot water heater. This chamber has to deal with the temperature of up to 85˚C and pressure up to 145 psi. The pressure inside makes the pressure vessel an internal pressure vessel. The reduction of weight of the pressure vessel without significant of any properties of pressure vessel also the safety of these vessel is prime concern as their failure loads to huge loss of properties. Thus, the ASME codes section X are widely used to design these pressure vessels that has in build factor of safety in the design procedure. Here, the whole pressure vessel is designed and optimization including shell, nozzle, end closures, using ASME Code section X. The optimum end closure design is selected by comparing them for cost and deflection. The designs are analyzed using ANSYS Multiphysics (Workbench 15.0) and validated by using Theory of Plates..

internal pressure vessel, ASME code, cylindrical pressure vessel, end closure

"DESIGN AND ANALYSIS OF COMPOSITE PRESSURE VESSEL AS PER ASME SECTION X ", International Journal of Emerging Technologies and Innovative Research (www.jetir.org), ISSN:2349-5162, Vol.6, Issue 4, page no.733-736, April-2019, Available :http://www.jetir.org/papers/JETIR1904G13.pdf

"DESIGN AND ANALYSIS OF COMPOSITE PRESSURE VESSEL AS PER ASME SECTION X ", International Journal of Emerging Technologies and Innovative Research (www.jetir.org | UGC and issn Approved), ISSN:2349-5162, Vol.6, Issue 4, page no. pp733-736, April-2019, Available at : http://www.jetir.org/papers/JETIR1904G13.pdf