• Sapan J shah
• Hardik R. Mehta

As the increase in the use of plastic products as compared to different material due its good strength and its light weight factor, the main challenge comes to its production with least cost to make it most economic. Therefore, one must find the most effective way to reduce the cost. Wastage of the material being one of the factors for the loss in the production must be reduced. Hence considering it as an important factor for the production loss research and development is important. Taking reference from the research and development of a plastic extrusion machine. The paper is based on the modification of a screen changer used in the machine to remove harmful contaminants from the material entering the dye. As observed practically, there’s a leak of material from the screen exchanger. So, the main aim of this research is solely based of optimizing the leakage occurring from the screen changer.

Screen exchanger design

"DETAIL STUDY & OPTIMIZATION OF LEAKAGE IN SCREEN CHANGER USED IN PLASTIC EXTRUSION MACHINE", International Journal of Emerging Technologies and Innovative Research (www.jetir.org), ISSN:2349-5162, Vol.6, Issue 4, page no.204-207, April-2019, Available :http://www.jetir.org/papers/JETIR1904J27.pdf

"DETAIL STUDY & OPTIMIZATION OF LEAKAGE IN SCREEN CHANGER USED IN PLASTIC EXTRUSION MACHINE", International Journal of Emerging Technologies and Innovative Research (www.jetir.org | UGC and issn Approved), ISSN:2349-5162, Vol.6, Issue 4, page no. pp204-207, April-2019, Available at : http://www.jetir.org/papers/JETIR1904J27.pdf