• ALOK KUMAR
• M.K Chopra

In the present work waste heat recovery system is meant to integrate the heat of' waste gas within the heat treatment furnace. For this purpose a case study of typical LPG cylinder fabrication industry is considered. The waste gas from heat treatment method exits at a temperature of around 450 - 500 °C. A lot of' sensible heat is lost with these gases. This heat is used for enhancing the performance of furnace in terms of their overall efficiency. The objective of this project is to style a suitable heat recovery system for on top of cases which might efficiently remove the sensible heat and place it to use. Once analysis and calculation half we have found that by utilizing recuperative kind air pre-heater the furnace thermal efficiency is enhanced by 9.515%. Conjointly because of planned system we tend to found an annual saving of 8,700 kg of furnace oil that close to value of Rs. 4.35lakhs

Waste Heat, Recovery, Waste Heat Utilization, Energy Efficiency

"PERFORMANCE ENHANCEMENT OF LPG CYLINDER FABRICATION BY UTILIZING WASTE HEAT FROM OIL FIRED FURNACE", International Journal of Emerging Technologies and Innovative Research (www.jetir.org), ISSN:2349-5162, Vol.6, Issue 4, page no.523-528, April-2019, Available :http://www.jetir.org/papers/JETIR1904M78.pdf

"PERFORMANCE ENHANCEMENT OF LPG CYLINDER FABRICATION BY UTILIZING WASTE HEAT FROM OIL FIRED FURNACE", International Journal of Emerging Technologies and Innovative Research (www.jetir.org | UGC and issn Approved), ISSN:2349-5162, Vol.6, Issue 4, page no. pp523-528, April-2019, Available at : http://www.jetir.org/papers/JETIR1904M78.pdf