• T.THARUN KUMAR
• M. PEERAIAH
• S.MADHU SUDHAN
• Dr.CHANDRASEKHARAREDDY

In the era of mass manufacturing, MRR (material removal rate) could be a major concern indeed in manufacturing utilizing conventional lathes. The main objective of modern manufacturing nowadays is to deliver high quality products and low cost in a short time. In order to improve quality and decrease cost, the material removal rate should be optimized. In machines, accurate dimensions are required, but with good product quality. The objective of the pilot study is to examine the MRR and surface roughness as quality targets, taking into consideration the speed, progress and depth of the cutting of 410 stainless steel utilizing the HSS tool utilizing the Taguchi and ANOVA strategies. The contribution rate of each factor is calculated utilizing ANOVA. The optimal parameter set for the boring handle was gotten through grayscale examination. The result of this investigation determines the optimum values of process parameters for effective and efficient operation. The result demonstrates that the optimal combination of operating parameters improved the performance of the machining process. The predicted results are found to be closer to experimental results.

ANOVA, TAGUCHI, HSS, MRR, Ra, GRA, STAINLESS STEEL410.

"OPTIMIZATION OF MACHINING PARAMETERS OF STAINLESS STEEL 410 FOR BORING OPERATION IN A LATHE BASED ON GRA", International Journal of Emerging Technologies and Innovative Research (www.jetir.org), ISSN:2349-5162, Vol.6, Issue 5, page no.231-240, May-2019, Available :http://www.jetir.org/papers/JETIR1905536.pdf

"OPTIMIZATION OF MACHINING PARAMETERS OF STAINLESS STEEL 410 FOR BORING OPERATION IN A LATHE BASED ON GRA", International Journal of Emerging Technologies and Innovative Research (www.jetir.org | UGC and issn Approved), ISSN:2349-5162, Vol.6, Issue 5, page no. pp231-240, May-2019, Available at : http://www.jetir.org/papers/JETIR1905536.pdf