• Mr. Sagar Namdev Sakharkar
• Dr. Shashikant S. Goilkar
• Mr. Manthan Patil
• Mr. Bhushan Sawant
• Sahil Sawant

Minimum quantity lubrication play an important role in reduction in environmental impact and improve quality of products. Commercially available lubricants such as mustard oil and palm oil is used as lubrication environment in turning performance of AISI 1045 steel material. Comparative machinability assessment of mustard oil and palm oil shows some effective difference in surface roughness value. Viscosity plays an important role in machinability condition. Surface roughness in term of Ra and Rq value are measured and compared with Mustard and palm oil using response surface methodology. Higher cutting speed of 200m/min observed better impact in reduction of surface roughness for mustard oil and medium cutting speed is suitable for palm oil of 120m/min cutting speed.

MQL, Turning, RSM, Surface roughness

"Turning Performance of AISI 1045 Steel using MQL Technology", International Journal of Emerging Technologies and Innovative Research (www.jetir.org), ISSN:2349-5162, Vol.6, Issue 5, page no.682-685, May-2019, Available :http://www.jetir.org/papers/JETIR1905E96.pdf

"Turning Performance of AISI 1045 Steel using MQL Technology", International Journal of Emerging Technologies and Innovative Research (www.jetir.org | UGC and issn Approved), ISSN:2349-5162, Vol.6, Issue 5, page no. pp682-685, May-2019, Available at : http://www.jetir.org/papers/JETIR1905E96.pdf