• Mr. Pankhil A. Patel
• Mr. Arpit N. Patel
• Mr. Hard H. Patel
• Mr. Parth J. Thakkar
• Mr. Darshan K. Bhatt

Cutting forces plays a vital role in machining process as they provide useful information not only for the work done but also for understanding the mechanics of machining process. Design cutting tool (Material & Geometry) and selection of proper cutting parameters. Machining is a process design to change, size, shape and surface of material removal of material by straining the material to fracture with a help of single point cutting tool, while operation various. Forces produce in machining lathe tool dynamometer can evaluate cutting forces induced. The sensing system measures the deflection in load cells and these signals are modified in to other quantity and compared in the form of forces on display system. A novel geometrical design of the dynamometer structure allowed the standard tool shank of the turning operation to be easily changed without altering the sensor system. The developed dynamometer can perform the cutting force measurement up to 2.0 kN. This report is focus on geometrical design, mathematical and design analyses that are significant role in force sensor developed and present an application of low cost sensing method in turning process. In present work, on attempt has been much to design and fabrication of tool force dynamometer for turning operation on basis of the technological design dedicated tool force design is being fabricated.

Force measurement, Load cell, Dynamometer, Optimization, Analysis

"DESIGN & FABRICATION OF TOOL FORCE DYNAMOMETER FOR TURNING OPERATION", International Journal of Emerging Technologies and Innovative Research (www.jetir.org), ISSN:2349-5162, Vol.6, Issue 5, page no.575-582, May-2019, Available :http://www.jetir.org/papers/JETIR1905G84.pdf

"DESIGN & FABRICATION OF TOOL FORCE DYNAMOMETER FOR TURNING OPERATION", International Journal of Emerging Technologies and Innovative Research (www.jetir.org | UGC and issn Approved), ISSN:2349-5162, Vol.6, Issue 5, page no. pp575-582, May-2019, Available at : http://www.jetir.org/papers/JETIR1905G84.pdf