• Vaidehi
• Pratijnya
• Sandhya
• Priyanka

Abstract: Feedstock preparation for Metal Injection Molding (MIM) is a very crucial step since deficiencies in quality of the feedstock cannot be corrected by subsequent processing adjustments. Hence, it is important that the quality of feedstock is homogeneous. At present the complete identification process of raw material at various stages is manual which leads to the creeping in of errors in the form of wrong identification of powders. There is no fool proof method to check these errors. These errors are of very high magnitude and cause huge financial loss. Hence, an attempt is made to prevent mix-up and provide fool proof tracking and tagging using RFID at various stages of compounding and molding.

IndexTerms: identification, tags, RFID, tracking, material mix up, MIM.

"RFID based system for prevention of material mix-up at various stages in Metal-Injection-Molding process.", International Journal of Emerging Technologies and Innovative Research (www.jetir.org), ISSN:2349-5162, Vol.6, Issue 6, page no.9-14, June-2019, Available :http://www.jetir.org/papers/JETIR1906291.pdf

"RFID based system for prevention of material mix-up at various stages in Metal-Injection-Molding process.", International Journal of Emerging Technologies and Innovative Research (www.jetir.org | UGC and issn Approved), ISSN:2349-5162, Vol.6, Issue 6, page no. pp9-14, June-2019, Available at : http://www.jetir.org/papers/JETIR1906291.pdf