• B. Melina Queen
• J. Ramesh
• B. Alankritha

A tubular exchanger can be designed relatively high heat and high pressure atmosphere pressure differences between the fluids. E tubular exchangers are mainly used for liquid to liquid. An attempt was made in this work it is to design a shell and tube heat by modeling techniques in CATIA V5 taking the inside diameter of the housing of 400 mm, and the length of the casing mm outer diameter 700 and 12.5 mm tube , the tube length is 800 mm and steel Oualemwad Shell 1008, a tube material as copper and brass. Shell made using modeling Assembly and pipes with water as the average case. Using ANSYS software and thermal analysis of the heat exchangers shell and tube, changing the tube material.The comparison between the experimental results, ANSYS. With the help of numerical results are available, and the design of shell and tube heat exchangers can be changed to improve efficiency

DESIGN AND THERMAL ANALYSIS OF HEAT EXCHANGER TUBES USING ANSYS

"DESIGN AND THERMAL ANALYSIS OF HEAT EXCHANGER TUBES USING ANSYS", International Journal of Emerging Technologies and Innovative Research (www.jetir.org), ISSN:2349-5162, Vol.6, Issue 6, page no.301-303, June-2019, Available :http://www.jetir.org/papers/JETIR1906334.pdf

"DESIGN AND THERMAL ANALYSIS OF HEAT EXCHANGER TUBES USING ANSYS", International Journal of Emerging Technologies and Innovative Research (www.jetir.org | UGC and issn Approved), ISSN:2349-5162, Vol.6, Issue 6, page no. pp301-303, June-2019, Available at : http://www.jetir.org/papers/JETIR1906334.pdf