• Prajakta Y. Chavan
• Prajakta Y. Chavan
• Ganesh E. Kondhalkar

Article suggests the main purpose to design and development of the speed spin test facility for confirmation of bearing alignment of rotating system for that we design test rig for checking spins (speeds) of rotating elements. Need of work would be is due to checking the appropriate rotations during the application used whether it gives proper rotations or not or bearing alignment or not. The rotating element by testing it on the test rig, conclude that it has proper spin tests and bearing alignment or not by giving it on highest speed rotations. Actual work include a rotating element runs at different rpm for several time intervals. So we design the test rig for testing the rotating element by design calculations, numerical calculations not experimentally is used to build the test rig. Depends on this we should know the accounting errors occur in rotating component at which it damages by due to temperature effect on it or by improper misaligned bearing and at what rpm level it should be. Then appropriate remedies are finding to minimize the damages or effects and give the proper rectification and again test the component. The features of this project is its speed as speed of motor increases by velocity ratio in two phases which finally gets appropriate speed of rotating system which is being needed.

3 Phase AC Squirrel Cage Induction Motor (175KW), Hydraulic Dynamometer, Pulleys, Flat Belt (Open belt), Plummer Blocks, Shaft, Test Bed etc

"DESIGN AND DEVELOPMENT OF SPIN TEST RIG FACILITY FOR F47 HYDRAULIC DYNAMOMETER", International Journal of Emerging Technologies and Innovative Research (www.jetir.org), ISSN:2349-5162, Vol.6, Issue 6, page no.671-678, June 2019, Available :http://www.jetir.org/papers/JETIR1906P97.pdf

"DESIGN AND DEVELOPMENT OF SPIN TEST RIG FACILITY FOR F47 HYDRAULIC DYNAMOMETER", International Journal of Emerging Technologies and Innovative Research (www.jetir.org | UGC and issn Approved), ISSN:2349-5162, Vol.6, Issue 6, page no. pp671-678, June 2019, Available at : http://www.jetir.org/papers/JETIR1906P97.pdf