• S.NARASIMHA NAIK
• K MADHU SREE
• K TRINATH KUMAR

A piston may be a device that reciprocates at intervals a cylinder. it's either captive by the fluid or it moves the fluid that enters the cylinder. the most perform of the piston of associate IC engine is to receive the impulse from the increasing gas and to transmit the energy to the rotating shaft through the rod. The piston should conjointly disperse an oversized quantity of warmth from the combustion chamber to the cylinder walls. Piston is created of solid Al thanks to its high heat transfer rate. One vital factor to require care whereas victimization it (cast aluminum) is, as a result of it expands appreciably on heating thus correct quantity of clearance must be provided alternatively it'll lead the engine to seize. For avoiding higher than downside during this project solid Al LM25,ASMT B548 Alloy, A383and AL7475-7351 goes to interchange with the Al Alloys. These materials have high strength and Elongation. The aim of project is to style a piston for 150cc engine victimization style calculations. 2nd drawing is formed by victimization parameters obtained and a 3D model of piston is intended using constant code Catia by using 2nd drawings. Couple field Analysis is to be done on the piston by varied parameters like thickness etc and conjointly by considering materials of Al Alloys. Analysis is to be done to verify the simplest combination of parameters and material for 2 wheeler piston that is finished in solid works.

Two wheeler piston, materials like LM25, ASMT B548 Alloy, A383and AL7475-735, Catia, ANSIS, Stress, Displacement, Thermal gradient and heat flux.

"STRUCTURAL AND THERMAL ANALYSIS OF PISTION ON VERIOUS MATERIAL", International Journal of Emerging Technologies and Innovative Research (www.jetir.org), ISSN:2349-5162, Vol.6, Issue 6, page no.64-74, June 2019, Available :http://www.jetir.org/papers/JETIR1906Q10.pdf

"STRUCTURAL AND THERMAL ANALYSIS OF PISTION ON VERIOUS MATERIAL", International Journal of Emerging Technologies and Innovative Research (www.jetir.org | UGC and issn Approved), ISSN:2349-5162, Vol.6, Issue 6, page no. pp64-74, June 2019, Available at : http://www.jetir.org/papers/JETIR1906Q10.pdf