• G.V.Saikiran
• Dr.N.Seshaiah

Five-hole pneumatic pressure probes are utilized to do the enduring state measurements of three parts, for example, velocity, inflow angles, static and all out pressures all the while for a point in a flow field. Flow measurement is significant. The nature of the flow impacts the plan and execution of the different streamlined parts like blowers, blowers, fans and turbines and so forth. Increasingly more research work is accessible in the field of flow measurement. Numerous procedures had been produced for measurement of flow like LDV, PIV and Hot wire anemometry. Every one of these systems are viable yet are expensive. In the present work, alignment of five hole pressure test is done. Writing survey uncovers that the flow measurement by test is extremely compelling since it can quantify flow parameters, for example, static and stagnation pressure, velocity of liquid stream. The test is exposed to realize flow field for adjustment. The velocity of the liquid stream is kept up at 25 m/sec and the test is adjusted for various yaw and pitch angles. In this work, planning of test withstanding pressure esteems, misshapenness, stress and strains are broke down for various composite materials in ANSYS. Looking at the aftereffects of every material settle better withstand materials .

DESIGN AND ANALYSIS OF A FIVE HOLE PRESSURE PROBE USING DIFFERENT MATERIALS

"DESIGN AND ANALYSIS OF A FIVE HOLE PRESSURE PROBE USING DIFFERENT MATERIALS", International Journal of Emerging Technologies and Innovative Research (www.jetir.org), ISSN:2349-5162, Vol.6, Issue 6, page no.749-757, June 2019, Available :http://www.jetir.org/papers/JETIR1907J95.pdf

"DESIGN AND ANALYSIS OF A FIVE HOLE PRESSURE PROBE USING DIFFERENT MATERIALS", International Journal of Emerging Technologies and Innovative Research (www.jetir.org | UGC and issn Approved), ISSN:2349-5162, Vol.6, Issue 6, page no. pp749-757, June 2019, Available at : http://www.jetir.org/papers/JETIR1907J95.pdf