• Dishank S Upadhyay
• Dr.Komal G Dave

This study has been done for the feasibility of the induction heating in hot machining process, specifically in the Hot Turning Methodology. The experimental setup has been prepared for the machining of the hard to cut material, the hard to cut materials are generally termed as it is having poor machinability. The hot turning methodology brings feasibility for machining hard to cut material at ease. The experimental setup introduced in this study is a unique setup. Lot of studies have developed different types of heating setup, that includes, Oxy acetylene flame heating, Ultrasonic Heating, Laser beam heating, Induction heating etc. This study will discuss the development and the selection of the Induction heating as a Heating application for the hot turning methodology of machining.

Hot Machining, Hot Turning, Induction Heating, Hard to Cut Material, Arduino, K Type Thermocouple, IR Thermometer

"Experimental Setup for Hot Turning using Induction Heating Application.", International Journal of Emerging Technologies and Innovative Research (www.jetir.org), ISSN:2349-5162, Vol.7, Issue 6, page no.1668-1674, June 2020, Available :http://www.jetir.org/papers/JETIR2006569.pdf

"Experimental Setup for Hot Turning using Induction Heating Application.", International Journal of Emerging Technologies and Innovative Research (www.jetir.org | UGC and issn Approved), ISSN:2349-5162, Vol.7, Issue 6, page no. pp1668-1674, June 2020, Available at : http://www.jetir.org/papers/JETIR2006569.pdf