• Mr. Sangani Kamleshkumar Bhagvanjibhai
• Dr. Mitesh A. Popat

The effects of the processing parameters different base parameter of polymer extruder like temperature, speed and rpm. Increasing temperature reduces the color deviation for these particular highly adjusted grades. Similar results were observed for feed-rate, where increasing the feed-rate decreased the amount of color deviation. By increasing rpm, color deviation also increases; however, the effect of rpm is not very significant as compared to temperature and feed-rate. In general, there are hundreds of variables involved in color deviation, but a proper understanding of formulation on a given production line and proper processing parameters leads to proper color production feed-rate. By using Minitab software to optimization parameter in full factorial method and ANOVA then concluded the effect of different parameters over other parameters and results seem useful to set in the machine concerning the quality of the final product. By using Solid works 2020 which more user-friendly software check geometrical parameters of each product. In Solid works 2020 having a simulation module that having capabilities to the simulation of real practical data put and find out the result concerning static and thermal analysis. There is a different product like a flat plate, circular plate, pocket plate, food plate, egg plate, bowl, and fruit bowl check geometric and strength parameter each product and check the outcome of the parameter of simulation likes Von mises Stress, Deformation, and Strain, also thermal analysis gives the result of temperature and thermal flux sustaining in the product. The optimization data of all results of the simulation are satisfied concerning static analysis and thermal analysis.

ANOVA, Solid works 2020, Parameters, Feed rate, Speed, Temperature.

"Experimental Investigations of the Influence of Process Parameters for Extrusion Machine during Expanded Polystyrene Foam Manufacturing", International Journal of Emerging Technologies and Innovative Research (www.jetir.org), ISSN:2349-5162, Vol.7, Issue 9, page no.1057-1062, September 2020, Available :http://www.jetir.org/papers/JETIR2009439.pdf

"Experimental Investigations of the Influence of Process Parameters for Extrusion Machine during Expanded Polystyrene Foam Manufacturing", International Journal of Emerging Technologies and Innovative Research (www.jetir.org | UGC and issn Approved), ISSN:2349-5162, Vol.7, Issue 9, page no. pp1057-1062, September 2020, Available at : http://www.jetir.org/papers/JETIR2009439.pdf