• Dipesh Patel
• Bhupendra Parmar
• Bhavesh Mewada

: Different types of abrasives are used in abrasive water-jet machining (AWJM) like garnet, aluminium oxide, olivine, silica sand, silicon carbide, etc. Experimental investigations were conducted to assess the influence of AWJM process parameters on surface roughness (Ra) of glass. It was found that the type of abrasive materials, hydraulic pressure, standoff distance and traverse rate were the significant control factors in controlling the Ra. The present work gives a comparative analysis of the performance of different parameters during abrasive water-jet machining of glass. Due to increase in cutting speed and S.O.D. roughness is also increase. Increasing the hydraulic pressure and abrasive mass flow rate may result in a better machining performance for both criteria and decreasing the standoff distance and traverse rate may improve both criteria of machining performance.

Water Jet machine, Glass, Surface Roughness

"EFFECT DISSIMILAR PARAMETERS FROM ABRASIVE WATER JET MACHINING WITH GLASS MATERIAL", International Journal of Emerging Technologies and Innovative Research (www.jetir.org), ISSN:2349-5162, Vol.7, Issue 10, page no.1311-1314, October-2020, Available :http://www.jetir.org/papers/JETIR2010169.pdf

"EFFECT DISSIMILAR PARAMETERS FROM ABRASIVE WATER JET MACHINING WITH GLASS MATERIAL", International Journal of Emerging Technologies and Innovative Research (www.jetir.org | UGC and issn Approved), ISSN:2349-5162, Vol.7, Issue 10, page no. pp1311-1314, October-2020, Available at : http://www.jetir.org/papers/JETIR2010169.pdf