• Prashant Kumar Tiwari
• Atik Zafar khan
• Soumlaya maity
• Piyush kumar rai
• Nafees alam

As we tend to move towards the developed country, the necessity of fuel is increasing day by day with an increasing population. we'd like various to switch fuel. In an IC engine, the chemical energy gets reborn into energy, i.e., the low-grade energy gets reborn into high-grade energy. The IC engine we tend to use causes additional pollution. therefore to beat this drawback, the magnetic attraction force is used to run the engine. The magnetic attraction engine that uses electrical energy to run, will replace the utilization of the IC engine. As we tend to pass current through the copper wire winding, the flux generated close to the copper wire. The polarity of the flux will vary per this. The magnet hooked up at the piston gets attracted up because of the polarity of the static magnet and this force is transferred to the rod and shaft assembly, which transfers the reciprocatory motion of the piston into the rotating motion of the crankshaft and at last the regulator

Magnet, Magnetic attraction coil, Relay, Battery, I R sensor, Piston.

"Design and development of solenoid engine ", International Journal of Emerging Technologies and Innovative Research (www.jetir.org), ISSN:2349-5162, Vol.8, Issue 5, page no.e458-e464, May-2021, Available :http://www.jetir.org/papers/JETIR2105601.pdf

"Design and development of solenoid engine ", International Journal of Emerging Technologies and Innovative Research (www.jetir.org | UGC and issn Approved), ISSN:2349-5162, Vol.8, Issue 5, page no. ppe458-e464, May-2021, Available at : http://www.jetir.org/papers/JETIR2105601.pdf