• PRATIK SUNILDATTA RAMTEKE
• Prof. Vipin Muley

The point of convergence of this paper to improvement power quality in wind energy system with the help of STATCOM (Static compensator). The unprejudiced of this interpretation is to examine power quality problem due to installation of wind turbine with the grid. The major power quality measurements are- the active power, reactive power, voltage (sag, swell), flicker, harmonics and electrical behavior of switching operation are measured according to national or international guidelines. The static compensator (STATCOM) is Implemented at a distribution level with a battery energy storage system (BESS) to mitigate the power quality issues. The major functional need of the STATCOM in this paper are to provide shunt compensation, operating in capacitive mode only, in terms of the following; voltage stability control in a power system, as to compensate the loss voltage along transmission. Here two control schemes for STATCOM are compared: Bang-Bang current controller and Fuzzy logic controller. The STATCOM control scheme for the grid connected wind energy generation system for power quality improvement is simulated using MATLAB/SIMULINK in power system bock set.

PV Grid, Wind Turbine, Total Harmonic Distortion, and Point of Common Coupling

"POWER QUALITY IMPROVEMT BY USING STATCOM CONTROL SCHEME IN WIND ENERGY GENERATION INTERFACE TO GRID", International Journal of Emerging Technologies and Innovative Research (www.jetir.org), ISSN:2349-5162, Vol.8, Issue 12, page no.e522-e524, December-2021, Available :http://www.jetir.org/papers/JETIR2112464.pdf

"POWER QUALITY IMPROVEMT BY USING STATCOM CONTROL SCHEME IN WIND ENERGY GENERATION INTERFACE TO GRID", International Journal of Emerging Technologies and Innovative Research (www.jetir.org | UGC and issn Approved), ISSN:2349-5162, Vol.8, Issue 12, page no. ppe522-e524, December-2021, Available at : http://www.jetir.org/papers/JETIR2112464.pdf