• Vedant Lohar
• Bhakti Sutar
• Vaishnavi Alhat
• Atharva Kulkarni
• Jayshree Mundada

In this project we are building an automatic road block using the Arduino Mega 2560. We are using an automatic road block to control the speed of the car. If the signal is red, then the speed breaker goes off the road automatically. After the signal turns green the speed bump automatically shuts off. In the fast-paced world, there are two perspectives, one that controls speed and the other that maintains a safety net. So speed control is very easy for a person and in a safe situation, there should be a lot of attention. For the purpose of safety, as well as to prevent accidents on the road, we can use a different method of using a speed breaker in concrete on the road. The main objective of this project is to control the speed of vehicles, to reduce the risk of near urban areas and restricted areas such as school grounds, parks, hospital areas and short turns, to provide first aid / full access to emergency vehicles such as ambulances, police van, etc. It even creates traffic flow and avoids traffic congestion. It also enables the public to cross the road without the risk of speeding traffic. It can be conveniently installed at airports and in factories wherever pedestrians and cyclists share space with high-speed vehicles.

Traffic, Roadblock, Traffic Signal, DC Motor, Road Safety

"Pre-Programmed Road Block Using Arduino Mega 2560", International Journal of Emerging Technologies and Innovative Research (www.jetir.org), ISSN:2349-5162, Vol.9, Issue 4, page no.d452-d455, April-2022, Available :http://www.jetir.org/papers/JETIR2204359.pdf

"Pre-Programmed Road Block Using Arduino Mega 2560", International Journal of Emerging Technologies and Innovative Research (www.jetir.org | UGC and issn Approved), ISSN:2349-5162, Vol.9, Issue 4, page no. ppd452-d455, April-2022, Available at : http://www.jetir.org/papers/JETIR2204359.pdf