• Ketan S. Kumbhar
• Manoj U. Deosarkar

The principle objective of this project is to design and analysis two lane flyover using Staad. Pro. The location of the flyover is at Solapur national highway 04 which is facing major traffic problems. Completion of the flyover work is expected to ease traffic movement on the Solapur Road. The flyover is a part of the 2-km new Vijapur Road. The flyover is of 420m length with 08 spans, 14m per each span. The diameter of the pier is about 2.5m and the Beams are of I-section. The height of the columns is 4.2m .The Flyover has a road width of 8m (2lanes), in which 0.5m is of median. It also consists of footpath of 2m width. In the post processing mode after completion of the design we have worked on the structure and studied the bending moment and shear force values.

Fly over, design parameters, bending moment shear force, post processing, Staad pro

"ANALYSIS AND DESIGN SINGLE PIER (2 LANE) FLYOVER BY USING STAAD PRO CONNECT", International Journal of Emerging Technologies and Innovative Research (www.jetir.org), ISSN:2349-5162, Vol.9, Issue 5, page no.c222-c230, May-2022, Available :http://www.jetir.org/papers/JETIR2205234.pdf

"ANALYSIS AND DESIGN SINGLE PIER (2 LANE) FLYOVER BY USING STAAD PRO CONNECT", International Journal of Emerging Technologies and Innovative Research (www.jetir.org | UGC and issn Approved), ISSN:2349-5162, Vol.9, Issue 5, page no. ppc222-c230, May-2022, Available at : http://www.jetir.org/papers/JETIR2205234.pdf