• SHITAL BHOSALE
• SAMARTH GHAM
• DHEERAJ RANE

The scope of this project is to give surface finishing to Intake manifold. On Lathe Machine by using Jig & fixture. Jig is device which is used to hold the work piece or fix the work piece and guide the cutting tool. The purpose of the jigs is to provide strength, holding, accuracy and interchangeability in the manufacturing of product. The objective of this project is to design and development of jig & fixture. Productivity & quality are the major factor for growth of our Indian manufacturing sector. The total machining time is reduced by 7 min per component which improves the productivity. In various industries the verity of job is less and high quantity of job produced. Because of high productivity mass production up to the increment of 32760 job per year occurs, this is possible when reducing total cost and saving time.so mass production is achieved by use of fixtures. In this project the design of fixture for drilling operation and facing operation from the both sides. Such fixture are made accurate and precise drilled hole and also individual positioning, marking, frequent checking are eliminated. Fixtures are the tool used to locate and hold the work piece in position during the manufacturing process. So we design the fixture 3D model by using design software’s (Creo, Catia, cad) etc.

JIG AND FIXTURE, CLAMPING, ETC

"DESIGN OF JIG & FIXTURE FOR SURFACE FINISHING OF INTAKE MANIFOLD", International Journal of Emerging Technologies and Innovative Research (www.jetir.org), ISSN:2349-5162, Vol.9, Issue 5, page no.j524-j527, May-2022, Available :http://www.jetir.org/papers/JETIR2205A67.pdf

"DESIGN OF JIG & FIXTURE FOR SURFACE FINISHING OF INTAKE MANIFOLD", International Journal of Emerging Technologies and Innovative Research (www.jetir.org | UGC and issn Approved), ISSN:2349-5162, Vol.9, Issue 5, page no. ppj524-j527, May-2022, Available at : http://www.jetir.org/papers/JETIR2205A67.pdf