• B. Chenna kesava reddy
• C.H. Devendra reddy
• B. Rakesh
• A. Veerraju , B. Vivek
• Dr.S. Sudhakar babu

The current project is to fabricate a mechanism that harvests energy from the speed breaker by rack and pinion arrangement. The principle involved in the present work is to convert the potential energy of the speed breaker into electrical power. Large amounts of electricity can be generated, thus saving a lot of money, and will be very beneficial for the Government. When a vehicle is in motion it produces heat energy due to friction between the vehicle’s wheel and the road and also when the vehicle strikes the wind at high speeds. There is a system to generate power by converting the potential energy generated by a vehicle going up on a speed breaker into kinetic energy. When the vehicle moves over the inclined plates, it gains height thus resulting in an increase in potential energy, which is wasted in a conventional rumble strip. When the breaker comes down, they crank a lever fitted to a ratchet-wheel type mechanism (an angular motion converter) which in turn rotates a geared shaft that is loaded with recoil springs. The output of this shaft is coupled to a dynamo to convert kinetic energy into electrical energy.

vehicles, speed breaker, rack and pinion, gear shaft, dc generator, power generation

"POWER GENERATION USING SPEED BREAKER WITH HELP OF RACK AND PINION MECHANISM", International Journal of Emerging Technologies and Innovative Research (www.jetir.org), ISSN:2349-5162, Vol.10, Issue 3, page no.b747-b752, March-2023, Available :http://www.jetir.org/papers/JETIR2303198.pdf

"POWER GENERATION USING SPEED BREAKER WITH HELP OF RACK AND PINION MECHANISM", International Journal of Emerging Technologies and Innovative Research (www.jetir.org | UGC and issn Approved), ISSN:2349-5162, Vol.10, Issue 3, page no. ppb747-b752, March-2023, Available at : http://www.jetir.org/papers/JETIR2303198.pdf