• Ragupathi.E
• Vigneshprabhu.M
• Dinesh prabhu.S
• Sridhar.V
• Sree Abilash.S

The main goal of this project is to build a can crushing device that will lower the amount of scrap and make it easier to transport cans to the recycling facility. Nowadays, a lot of cans are used in hotels, canteens, and other establishments, and a lot of room is needed to store or dispose of the old cans. This project involves building a can crusher with a single slider crank mechanism that will at least 70% decrease the volume of cans. This paper details the calculations, assembly, and machine manufacturing that were required. There have been two Can Crushers built as part of this project. The first one was manually controlled and was created during the seventh semester.

Pneumatic FRLUnit solenoidvalve

"DESIGN AND FABRICATION OF PNEUMATIC AND MANUAL TIN CRUSHER", International Journal of Emerging Technologies and Innovative Research (www.jetir.org), ISSN:2349-5162, Vol.11, Issue 2, page no.c712-c713, February-2024, Available :http://www.jetir.org/papers/JETIR2402285.pdf

"DESIGN AND FABRICATION OF PNEUMATIC AND MANUAL TIN CRUSHER", International Journal of Emerging Technologies and Innovative Research (www.jetir.org | UGC and issn Approved), ISSN:2349-5162, Vol.11, Issue 2, page no. ppc712-c713, February-2024, Available at : http://www.jetir.org/papers/JETIR2402285.pdf