• C G MOHAN BABU
• K HARIKA
• G SREENIVAS
• S SWETHA
• J VENKATESH

In a smart irrigation system, we read the soil moisture value and control the water pump using controllers like Arduino, raspberry Pico and etc. But it is quite costly and overwork. For reducing the troubles here we simply using the components Moisture sensor, Relay module, DC pump, Regulator and wires. In this method we simply power the moisture sensor and Relay using the 9V battery and 7805 Regulator. If the sensor properly worked then we connect the output of the moisture sensor to the Relay module input. Then the low moisture detected from soil the automatically switch on the Relay. Here the Dc pump is attached with relay module. Then pump will pump the water. In case the soil Moisture is get enough water then the relay will automatically off

Moisture Sensor,Relay Module,Battery,Liquid Limit

"SUSTAINABLE FARMING WITH SMART IRRIGATION TECHNOLOGY", International Journal of Emerging Technologies and Innovative Research (www.jetir.org), ISSN:2349-5162, Vol.11, Issue 4, page no.k125-k130, April-2024, Available :http://www.jetir.org/papers/JETIR2404A19.pdf

"SUSTAINABLE FARMING WITH SMART IRRIGATION TECHNOLOGY", International Journal of Emerging Technologies and Innovative Research (www.jetir.org | UGC and issn Approved), ISSN:2349-5162, Vol.11, Issue 4, page no. ppk125-k130, April-2024, Available at : http://www.jetir.org/papers/JETIR2404A19.pdf